Introduction to Arduino and programming . Practicals which use this tutorial have an introductory presentation (pdf). We will build a temperature sensor in this tutorial and connect it with an App. It uses an DHT11 temperature & humidity sensor and Bluetooth communication with a phone. We use a BLE-Nano here, but you can also use a regular Arduino … Continue reading Tutorial: build a connected temperature sensor
This tutorial describes how to build an electronic circuit with an RGB LED (a LED that can change color), and change its color using an App. It also demonstrates two-way communication over Bluetooth LE between an App built with App Inventor and the BLE-Nano board. The BLE-Nano board is basically an Arduino Nano with an … Continue reading Bluetooth communication between an App built with App Inventor and the BLE-Nano board
The BLE-Nano as sold here is a combination of a traditional Nano with a Bluetooth BLE module, based on the CC2540 BLE bluetooth chip. The Bluetooth module is directly connected to the TX, RX pins of the Arduino (pins 0 and 1). There is a troubleshooting section further down on this page! This is the … Continue reading Introduction to the Arduino BLE Nano